HowTo Configure Breakout Cables 40G => 4x10G Using Cumulus Linux


This post describes how to configure breakout cable 40 => 10Gb/s using Cumulus Linux OS.
This post assumes that you already have Cumulus Linux installed on a Mellanox Spectrum switch.

https://community.mellanox.com/docs/DOC-2685

2 replies

Userlevel 3
Thanks for posting this Ophir! I double checked and realized our docs were a little out of date wrt breakouts, so I updated that section (as well as other parts of the L1 chapter).
Sure.

Reply