Question

setup frr

  • 11 July 2019
  • 1 reply
  • 75 views

I'm watching a video on how to set this up. When I run these commands the frr daemon file on the leaf switch gets wiped out and the only option is zebra=yes. All of the contents are gone. In the video it doesnt do this.

!OOB Setup!
net add int eth0 ip add 192.168.101.163/24
net add int eth0 ip gateway 192.168.101.254
net add int eth0 alias mgmt
net add int eth0 vrf mgmt

!Interfaces!
net add interface swp1-2 mtu 9216
net add loopback lo ip add 10.0.0.3/32

!VNI- only on leaf switch and border. Map VNI to VRF!
net add vlan 4001 vlan-id 4001
net add bridge bridge vids 4001
net add vxlan routehub vxlan id 104001
net add vxlan routehub bridge access 4001
net add vrf routehub-vrf vrf-table auto
net add vrf routehub-vrf vni 104001
net add vlan 4001 vrf routehub-vrf
net add vxlan routehub vxlan local-tunnelip 10.0.0.3

!Add vlans. Not trunking but extending L2 over L3!
net add vlan 201 vlan-id 201
net add bridge bridge vids 201
net add bridge bridge ports swp6
net add interface swp6 bridge access 201

!Assign IP to vlans!
net add vlan 201 routehub-vrf
net add vlan 201 ip add 172.17.201.3/24
net add vlan 201 ip address-virtual 00:00:00:00:00:aa 172.17.201.1/24
net com
net show bridge vlan
net sh vrf

!FRR on all switches!
sudo nano /etc/frr/daemons
sudo systemctl enable frr.service
sudo systemctl start frr.service
ps -aux | grep frr






1 reply

Userlevel 4
Hi @xloveusa what video are you watching? Can you provide a link please?

Reply