cannot see network adapters in the cli of cumulus-vx

  • 8 October 2015
  • 3 replies

I am running cumulus-vx in virtualbox and i configured 4 adapters of the cumulus vm from gui of virtualbox. But when i go to cli of cumulus-vx , i can only see eth0 and l0. But ,it should show other adapters. Here are the pics

Please help me

3 replies

Userlevel 1
"ifconfig" will only show adaptors that are up and configured. If you want to see un-configured interfaces, use the "ifconfig -a" or "ip link" commands.
Userlevel 1
A-ha! I hit this as well. You need to enable the switch port interfaces now (and then quagga).

Take a look at this guide near the end:

Good luck, and let us know!